AC lines

thanks guys, glad it is running! After a little research it looks like the pushrods are a little short. So I have a set of 7.450 on order. The ones in it now are 7.400. That should add a bit more preload on the lifters and quiet down the valve train some.

Worked on the AC lines today.
These are the crimped low side to compressor (short line) and high side from compressor to condenser.

In the tool and pre crimp

post crimp

Entire crimping tool/setup

Heater hoses also done…AC lines feeding up to the drier (not connected yet) and the low side to the evap.

Bad picture…but where it goes up front..

Other side before it goes to the condenser.

Hooking to the condenser

Cart