shifter #3

Turn cardboard into metal…

[img]https://lh6.googleusercontent.com/-Kxo_fMv4des/UW3Ksh2u87I/AAAAAAAAGG4/1gvsqT9xwf0/s640/IMAGE_BB45028C-832C-4996-BC3E-4A0325E6BE78.JPG[/img]

[img]https://lh4.googleusercontent.com/-ceSIwLjlvH0/UW3Ku4r3xMI/AAAAAAAAGHA/Ie0zNt6b2lo/s640/IMAGE_6627A13B-5E4D-4B46-BF4C-D5F6A3CCA715.JPG[/img]

[img]https://lh5.googleusercontent.com/-sy-i5hOouGw/UW3KyHinU0I/AAAAAAAAGHI/GgzrZMZ-89g/s640/IMAGE_F4BE8A63-F3CB-4548-9D6D-BFBEC5981358.JPG[/img]

[img]https://lh5.googleusercontent.com/-NriyNyW9Jq4/UW3K0VvSIGI/AAAAAAAAGHQ/T2DT22_gkRc/s640/IMAGE_014A5FBE-C958-495B-B73A-16C11184A9B1.JPG[/img]

Rear will mount off the trans… something like this
[img]https://lh6.googleusercontent.com/-RD0G1gMGZkY/UW3K6y6FK0I/AAAAAAAAGHo/pYB5IGunX3o/s640/IMAGE_286971DD-3E1B-4B87-8131-AA82208535E4.JPG[/img]

This piece of metal will be cut where the line is after I drill a hole on each side of the big hole going up from the bottom. Then I will tap the upper half so it is easier to take the entire assembly in and out.

The entire thing will be powder coated.

Cart