Cutting an oil pan

Pulled the pan to cut it apart.
Engine is VERY clean inside.
[img]https://lh5.googleusercontent.com/-ODtUjP8umkw/Uv4Qk49rLEI/AAAAAAAAKzQ/d4VVHdO-1D0/s640/IMAGE_1498.jpeg[/img]

[img]https://lh4.googleusercontent.com/-GjRbAHfKWeE/Uv4Qqn53m5I/AAAAAAAAKzo/z4KHvxutG3c/s640/IMAGE_1501.jpeg[/img]

[img]https://lh5.googleusercontent.com/-3rBAQHxBC0g/Uv4QubutlZI/AAAAAAAAKz4/8QpOiueeP_c/s640/IMAGE_1503.jpeg[/img]

Time to cut the pan…
[img]https://lh4.googleusercontent.com/-asDT6bZF9ig/Uv4Q0Rj0d-I/AAAAAAAAK0Q/Y9o88vkB9Rc/s640/IMAGE_1506.jpeg[/img]

[img]https://lh5.googleusercontent.com/-wf08SBkSlz8/Uv4Q3zvn0KI/AAAAAAAAK0Y/kwdkqvFmiZw/s640/IMAGE_1507.jpeg[/img]

[img]https://lh5.googleusercontent.com/-5nVlHE-tTQs/Uv4Q9rNw2mI/AAAAAAAAK0w/y1itx7tvQ2M/s640/IMAGE_1510.jpeg[/img]

[img]https://lh6.googleusercontent.com/-V8Po07nS8Ow/Uv4Q_cjKOgI/AAAAAAAAK04/aihrGy1V5-c/s640/IMAGE_1511.jpeg[/img]

To keep it sealed up
[img]https://lh3.googleusercontent.com/-kaWxzIQlGKA/Uv4RCEgk1_I/AAAAAAAAK1A/LghlOJAv9OE/s640/IMAGE_1512.jpeg[/img]

This picture is without the trans on. The pan actually sits closer than this to the subframe/rack mounting.
[img]https://lh6.googleusercontent.com/-fjRlmmD4vWs/Uv4Q5dpyV1I/AAAAAAAAK0g/9JT1tj_GeGs/s640/IMAGE_1508.jpeg[/img]

The trans tunnel had to be opened up in one spot to get things to fit better.
A little bit of heat and a hammer did the job.
[img]https://lh5.googleusercontent.com/-BnJQv-10f9E/Uv4RHiuo4kI/AAAAAAAAK1Y/gMGVcNrst6M/s640/IMAGE_1515.jpeg[/img]

Getting closer to it’s final home
[img]https://lh6.googleusercontent.com/-crgfAIElInY/Uv4RJn5x2EI/AAAAAAAAK1g/0hSA5pIzcvk/s640/IMAGE_1516.jpeg[/img]

Cart